| [an error occurred while processing this directive]
|
|
|
|
|
|
|
Home > Categories > Heaters > Flameless Heater Trailer > Flameless Heater Trailer Additional Information |
|
| |
|
|
|
|
| |
THDY-600DR Flameless 600k BTU Diesel Heater Trailer
Additional Information
THDY-600DR Flameless 600K BTU Diesel Heater Trailer
Oil and Methane Gas fields - Complying with OSHA regulations:
The Model 600DR, known as the "Rig Heater" is a flameless heater. Meaning there is no open flame and even the alternator is spark-less. OSHA requirements prevent, "open flamed type heaters for use on the rig floor, substructure, or cellar." You can set this Rig Heater next to the wellhead for worker comfort and not be violating these OSHA requirements.
Construction sites:
The Model 600DR industrial heater provides multiple uses on commercial construction sites. This heating unit will provide clean, dry, contaminate-free air for worker comfort for equipment maintenance in the winter. It can be used for thawing pipes or providing warm air for preparation of concrete work. It can thaw ground, or be used as a heating source to aid in the curing process for concrete or interior and exterior finishes. It is self-contained and requires no electricity.
Flood clean up:
For use in cleaning up after a flood or fire related water damage, the Model 600DR is again a leader in providing clean dry air. The unit may be used inside or outside the structure and is safer and more efficient than electric heaters or gas heaters (direct fired, indirect fired, infrared heaters or furnaces). The 600 DR does not have a fuel-fired flame to add moisture to the air. Thus, discharge air is clean and dry.
Safety
The Model 600 DR utilizes several safety features to protect both employees and your investment in the unit. It uses a brushless alternator to reduce the possibility of sparks generated in the engine compartment. Secondly, the absence of an open-flame reduces the chances of spontaneous combustion of flammable gases that may be present in the working environment. In addition, removal of an open flame heat source eliminates carbon monoxide gases and high moisture contents from heated air, leaving a safe, comfortable working environment. Even the exhaust heat exchanger safely draws temperatures of the exhaust stack to a level employees will not get burned if contact with the stack occurs. Exhaust may be vented outside the work area, leaving the area contaminate free.
Further safety features are incorporated to protect your investment. All products may be equipped with a set of shut-off switches that: 1) shut engine down water temperature exceeds 210 degrees F, 2) engine oil pressure drops to 25 psi, 3) engine speed exceeds 200 rpm above throttle governor speed, and 4) hydraulic plate oil pressure drops to 5 psi.
This unit meets or exceeds OSHA, MSHA, and API standards for use in most areas.
|
|
|
|
|
|
|
|
|
Details and Accessories
|
|
600K BTU Flameless, Sparkless Diesel Heater Trailer - THERM-600DR |
|
|
|
- Caterpiller 6.6 litre Diesel Powered; No generator or elec power needed.
- Pulls right up to a rig without OSHA setbacks
- 600K BTU/hr; >6,000 CFM; 160º F Exit Temp
- 15" Wheels; 5300 lb Torsion Bar Axle, 16" Duct Storage Area
- Skid Mounted Available, same price.
- 14'L x 5'W x 7' Tall; 3,565 lbs, Requires Operation Training
- Unit is in very HIGH demand. Call now! |
|
|
|
|
|
|
|
|
|
|
|
|
|
Click For Larger Images |
|
|
|
|
 |
|
Heat Generating Unit
- 600,000 BTU of Heat
- l6,000 CFM of uncontaminated air
- Maximum Temperature 170degreeF
- No open flame
- Portable and Self Contained l120 or 170 Gallon Fuel Tank
|
|
|
|
|
|
|
|
 |
|
Diesel Power Source
- 3056 Tier II CAT Diesel Engine
- Tier II meets all EPA Emission Controls
Control Panel
Two Murphy Gauges, Engine:
- Low oil pressure
- High Water Temp
Two Murphy Gauges, Heat Generator:
- Low oil pressure
- High oil temperature
Tachometer
Starter Control Switch
Murphy Override Switch
Throttle Control for engine- CAT is preferred because of its availability of parts and service
|
|
|
|
|
|
|
|
  |
|
Oil Reservoir & Hydraulic Filter - Maintenance
Equipped with two sight glasses and one hydraulic filter. Contains 10 quarts of Hydraulic Fluid, which needs to be changed every 1500 hours. This along with the recommendations of the engine manufacturer, is the only maintenance required for this unit.
|
|
|
|
|
|
|
|
 |
|
Thermostat Control
Thermostat is mounted directly on the control panel. By adjusting the thermostat to a desired temperature you vary the temperature of the air passing through the air discharge outlets. This in turn will adjust the automatic shutters to control the desired amount of air entering through the front of the unit.
|
|
|
|
|
|
|
|
  |
|
Engine Safety Features
- Explosion-proof alternator
- No brushes to create sparks
- Automatic Air Shut Off closes the air intake and shuts down the engine in the event of increased RPM’s due to the engine taking in flammable gas fumes.
|
|
|
|
|
|
|
|
  |
|
Exhaust Heat Exchange
Taking the exhaust from engine at approximately 9000 through the exhaust heat exchange in the rear, up to the secondary exhaust heat exchange in the front (coldest air), the unit recovers all but a small amount of heat. The radiant heat from the radiator and engine coupled with exhaust heat as the cold air is taken in, propelled by fan in the front of the engine.
Heat Plate
- l16" disk enclosed in heavy steel case
- Oil enters from the center onto the bearings and is moved to the outer edge.
- Disk agitates the oil aggressively to generate heat and load the engine.
- Released to oil galley, forced to the oil radiator. Heat is extracted from the oil and recycled.
|
|
|
|
|
|
|
|
 |
|
Dry Heated Air Discharge
The dry heated air is then discharged through the rear of the unit through 16" outlets. Tube ducting may be purchased for directed and extended discharge. The unit comes equipped with tube storage.
Portable – Self Contained
- 5200 lb. torflex axel
- Two Radial Tires ST225/75 R15
- Electric brakes
- Two tail lights
- Adjustable hitch
- Jack- Safety Chain
|
|
|
|
|
|
|
|
 |
|
Industrial Uses
Oil Fields and Oil Rigs
- Meets OSHA regulations for heat source
- Stand Alone Operation
|
|
|
|
|
|
|
|
|
|
Construction Sites
- Dryer for water restoration or clean up
- Heater during winter months
- No fire danger
|
|
|
|
|
|
|
|
[an error occurred while processing this directive]
|
