 |
 |
 |
||
 |
||||
| FSC16 RIP-R-STRIPPER® specifications |
||||
 |
||||
| POWER SOURCE | ||||
| Type | 3/4 hp (.56) totally enclosed, fan-cooled, capacitor-start, 1725 RPM, single-phase, 115/230 VAC, 60 Hz, electric motor. Factory wired to operate from 115 VAC power source. | |||
| Full Loaded Amperes (FLA) Rating | 10.3 amperes. Will operate on a clean, 15-amperes electrical circuit. | |||
| Electric Motor Start
Power Required (SPR) Rating. (SPR)=(FLA) x 5 Factor |
||||
| FRAME | ||||
| Structure | Unitized, welded-steel plate | |||
| External Weight System | 15 lbs. (6.8 kg) steel block, with quick attach-type fastener system | |||
| Drive System | Exciter unit mounted directly to motor driveshaft. Supported by threaded-stud type elastomeric mounts, deflection-limit stops and high-capacity ball bearings | |||
| Operator Handle | Adjustable height, ergonomically-positioned grip, foldable for transit and storage. | |||
| Wheel | ||||
| Wheel Scraper | 2 each, externally mounted, fully adjustable for wear compensation. | |||
| GENERAL | ||||
| Width | 14-1/23" (368 mm) | |||
| Width (At Operator Handle) | 23" (584 mm) | |||
| Height (Handle Folded) | 23" (584 mm) | |||
| Height 9At maximum Handle Extension) | 42" (1067 mm) | |||
| Length (Handle Folded) | 24" (610 mm) | |||
| Length (At Maximum Extension) | 34" (864 mm) | |||
| Weight (Included Weight, Less Blade) | 130 lbs. (59 kg) | |||
| Accessories | 6- inch (152 mm) straight blade, beveled edge
6- inch 9152 mm) angled mastic removal blade, beveled edge 8 inch (203 mm) straight scoring blade, for coverings adhered to concrete surfaces, beveled edge up. 8 inch (203 mm) straight scoring blade, for coverings adhered to wood surfaces, beveled edge down 10 inch (254 mm) straight blade, beveled edge 10 inch (254 mm) angled mastic removal blade, beveled edge 12 inch (305 mm) straight scoring blade, for coverings adhered to concrete surfaces, beveled edge up. 12 inch (305 mm) straight scoring blade, for covering adhered to wood surfaces, beveled edge down. 16 inch (406 mm) straight blade, with support bracket, beveled edge Ripper tooth attachment, ceramic tile, hardwood floor removal. |
|||
| All specifications are general in nature and are not intended for specific application purpose. General Equipment Company reserves the right to make changes in design, engineering, or specifications and to add improvements or discontinue manufacture at any time without notice or obligation. Consult the applicable operator manual and support material before utilizing the produce. Refer to OSHA 2207 and/or current revisions for specific information. Names depicted are the registered trademark of their respective owners. | ||||
|
||||||||||||||
|
